House wiring checklist: 10 things to check before plaster
17 November 2026 · Md Faizan Shibli, Electrical Engineer
In most houses, the conduits go into the walls before plaster. After plaster and paint, any mistake means breaking walls. So the best time to check your wiring is before plaster, while everything is still open.
Here is a simple checklist we use on our own sites.
1. Is there a wiring layout?
Every switch, socket, light and fan point should be marked on a plan before the conduit work starts. Without a layout, points get missed and you end up with extension boards everywhere.
2. Separate circuits for heavy loads
AC, geyser, kitchen appliances and the water pump should each be on their own circuit with their own MCB. Lights and fans can share circuits. Heavy loads should never run on a lighting circuit.
3. Right wire size
As a common rule for copper wire in homes:
| Circuit | Typical copper wire size |
|---|---|
| Lights and fans | 1.5 sq mm |
| Normal sockets (6/16 A) | 2.5 sq mm |
| AC, geyser | 4 sq mm |
The final size depends on load and cable length, so get it checked by an electrical engineer for big houses.
4. Good quality, ISI-marked material
Use ISI-marked wires (FR or FRLS), PVC conduits and boxes. Cheap wire is the most common reason for heating and short circuits.
5. Conduits are not overfilled
Too many wires in one conduit heat up and are hard to pull out later. If a wire ever needs to be replaced, it should come out easily.
6. Earth wire to every socket
Every socket and every metal fitting needs an earth wire running back to the DB. Earthing protects people from shock.
7. A proper earth pit
The earth wire is useless without a good earth pit. Earthing should be done as per IS 3043, and the earth resistance should be tested after installation.
8. DB with MCB and RCCB
The distribution board (DB) should have MCBs for each circuit and an RCCB for protection against shock and leakage. Keep a few spare ways for future use.
9. Height and position of points
Fix switch board heights, socket heights (kitchen, bed side, TV wall) and AC point positions now. Moving them later means breaking the wall.
10. Take photos before plaster
Take photos and a short video of every wall with conduits before plaster. Later, when you drill for a frame or a shelf, you will know where the pipes are.
Building a house in Darbhanga, Madhubani, Samastipur or Muzaffarpur? We can prepare the wiring layout and do the complete wiring work. Call or WhatsApp us for a site visit.